Big discounting Polyvinylidene Fluoride Membrane - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2880 Replacing Project – Bangmo
Big discounting Polyvinylidene Fluoride Membrane - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2880 Replacing Project – Bangmo Detail:
Applications
Drinking treatment of tap water, surface water, well water and river water.
Pretreatment of RO.
Treatment, recycle and reuse of industrial waste water.
Filtration Performance
This product is proven to have below filtering effects according to the service conditions of different water sources:
| Ingredient | Effect |
| SS, Particles > 1μm | Removal Rate ≥ 99% |
| SDI | ≤ 3 |
| Bacteria, Viruses | > 4 log |
| Turbidity | < 1NTU |
| TOC | Removal Rate: 0-25% |
*Above data is obtained under the condition that feeding water turbidity is < 25NTU.
Product Parameters
Technical Parameters
| Filtering Type | Outside-in |
| Membrane Material | Modified PVDF |
| MWCO | 200K Dalton |
| Membrane Area | 77m2 |
| Membrane ID/OD | 0.8mm/1.3mm |
| Dimensions | Φ225mm*2360mm |
| Connector Size | DN50 Clamping; Air Inlet – 10mm air pipe |
Application Data
| Pure Water Flux | 11,000L/H (0.15MPa, 25C) |
| Designed Flux | 40-120L/m2.hr (0.15MPa, 25C) |
| Suggested Working Pressure | ≤ 0.2MPa |
| Maximum Transmembrane Pressure | 0.15MPa |
| Maximum Backwashing Pressure | 0.15MPa |
| Air Washing Volume | 0.1-0.15N m3/m2 .hr |
| Air Washing Pressure | ≤ 0.1MPa |
| Maximum Working Temperature | 45C |
| PH Range | Working: 4-10; Washing: 2-12 |
| Operating Mode | Cross Flow or Dead End |
Feeding Water Requirements
Before feeding water, a security filter < 50 μm should be set to prevent blockage caused by large particles in raw water.
| Turbidity | ≤ 25NTU |
| Oil & Grease | ≤ 2mg/L |
| SS | ≤ 20mg/L |
| Total Iron | ≤ 1mg/L |
| Continuous Residual Chlorine | ≤ 5ppm |
| COD | Suggested ≤ 500mg/L |
*Material of UF membrane is polymer organic plastic, there must not be any organic solvents in raw water.
Operating Parameters
| Backwashing Flow Rate | 100-150L/m2.hr |
| Backwashing Frequency | Every 30-60min. |
| Backwashing Duration | 30-60s |
| CEB Frequency | 0-4 times per day |
| CEB Duration | 5-10min. |
| CIP Frequency | Every 1-3 months |
| Washing Chemicals: | |
| Sterilization | 15ppm Sodium Hypochlorite |
| Organic Pollution Washing | 0.2% Sodium Hypochlorite + 0.1% Sodium Hydroxide |
| Inorganic Pollution Washing | 1-2% Citric Acid/0.2% Hydrochloric Acid |
Component Material
| Component | Material |
| Membrane | Modified PVDF |
| Sealing | Epoxy Resins |
| Housing | UPVC |
Product detail pictures:
Related Product Guide:
We depend on sturdy technical force and continually create sophisticated technologies to meet the demand of Big discounting Polyvinylidene Fluoride Membrane - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2880 Replacing Project – Bangmo , The product will supply to all over the world, such as: Plymouth , Nepal , Nigeria , Only for accomplishing the good-quality product to meet customer's demand, all of our products have been strictly inspected before shipment. We always think about the question on the side of the customers, because you win, we win!
By Andrea
from Myanmar
- 2018.09.21 11:44
Product quality is good, quality assurance system is complete, every link can inquire and solve the problem timely!
By Lorraine
from New Zealand
- 2017.10.13 10:47
Write your message here and send it to us
