Factory Outlets Purification System - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo
Factory Outlets Purification System - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo Detail:
Applications
Drinking water treatment of tap water, surface water, well water and river water.
Pretreatment of RO.
Treatment, recycle and reuse of industrial waste water.
Filtration Performance
This product is proven to have below filtering effects according to the service conditions of different water sources:
| Ingredient | Effect |
| SS, Particles > 1μm | Removal Rate ≥ 99% |
| SDI | ≤ 3 |
| Bacteria, Viruses | > 4 log |
| Turbidity | < 1NTU |
| TOC | Removal Rate: 0-25% |
*Above data is obtained under the condition that feeding water turbidity is < 25NTU.
Product Parameters
Technical Parameters
| Filtering Type | Outside-in |
| Membrane Material | Modified PVDF |
| MWCO | 200K Dalton |
| Membrane Area | 47m2 |
| Membrane ID/OD | 0.8mm/1.3mm |
| Dimensions | Φ200mm*1710mm |
| Connector Size | DN50 Clamping |
Application Data
| Pure Water Flux | 9,400L/H (0.15MPa, 25C) |
| Designed Flux | 40-120L/m2.hr (0.15MPa, 25C) |
| Suggested Working Pressure | ≤ 0.2MPa |
| Maximum Transmembrane Pressure | 0.15MPa |
| Maximum Backwashing Pressure | 0.15MPa |
| Air Washing Volume | 0.1-0.15N m3/m2 .hr |
| Air Washing Pressure | ≤ 0.1MPa |
| Maximum Working Temperature | 45C |
| PH Range | Working: 4-10; Washing: 2-12 |
| Operating Mode | Cross-flow or Dead-end |
Feeding Water Requirements
Before feeding water, a security filter < 50 μm should be set to prevent blockage caused by large particles in raw water.
| Turbidity | ≤ 25NTU |
| Oil & Grease | ≤ 2mg/L |
| Suspended Solids | ≤ 20mg/L |
| Total Iron | ≤ 1mg/L |
| Continuous Residual Chlorine | ≤ 5ppm |
| COD | Suggested ≤ 500mg/L |
*Material of UF membrane is polymer organic plastic, there must not be any organic solvents in raw water.
Operating Parameters
| Backwashing Flow Rate | 100-150L/m2.hr |
| Backwashing Frequency | Every 30-60min. |
| Backwashing Duration | 30-60s |
| CEB Frequency | 0-4 times per day |
| CEB Duration | 5-10min. |
| CIP Frequency | Every 1-3 months |
| Washing Chemicals: | |
| Sterilization | 15ppm Sodium Hypochlorite |
| Organic Pollution Washing | 0.2% Sodium Hypochlorite + 0.1% Sodium Hydroxide |
| Inorganic Pollution Washing | 1-2% Citric Acid/0.2% Hydrochloric Acid |
Component Material
| Component | Material |
| Membrane | Modified PVDF |
| Sealing | Epoxy Resins |
| Housing | UPVC |
Product detail pictures:
Related Product Guide:
Our business puts emphasis over the administration, the introduction of talented staff, plus the construction of team building, attempting hard to boost the standard and liability consciousness of personnel customers. Our corporation successfully attained IS9001 Certification and European CE Certification of Factory Outlets Purification System - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo , The product will supply to all over the world, such as: Philippines , Czech republic , Jersey , Company name, is always regarding quality as company' s foundation, seeking for development via high degree of credibility , abiding by ISO quality management standard strictly, creating good -ranking company by spirit of progress-marking honesty and optimism.
By Beulah
from French
- 2018.12.30 10:21
We are long-term partners, there is no disappointment every time, we hope to maintain this friendship later!
By Dee Lopez
from Honduras
- 2018.12.22 12:52
Write your message here and send it to us
